7:6
B
A
Embroidery Mode - Preparations
Getting started embroidering
1. After attaching the embroidery unit and
embroidery foot, insert a bobbin with
lightweight bobbin thread.
Note: Make sure that the *%5 system is disengaged.
2. To select a design, open selection menu and
touch the design menu icon (A). Locate desired
design and touch it once to load to Embroidery
edit.
3. The machine automatically switches to
Embroidery edit. The design is placed in the
center of the hoop.
4. Hoop a piece of fabric and slide on the hoop.
5. Switch from Embroidery edit to Embroidery
stitch-out by touching the embroidery toggle
icon (B) on the task bar.
To Next Page
Loading...
