4:4
Stitch length +Stitch length -
10 12
11
26
Sewing mode
Stitch settings
Your machine will set the best settings for each
selected stitch. You can make your own adjustments
on the selected stitch.
The setting changes only affect the selected stitch.
Your changed settings will be reset to default when
selecting another stitch. The changed settings
are not automatically saved when turning your
machine off. You can save the adjusted stitch in
Personal menu.
Note: The set stitch width and the stitch length are
shown above the icons. When trying to exceed minimum
or maximum settings for width and length, a warning
sound will be heard.
The default value is shown in white. Value changes are
shown in green.
Stitch width (10)
Increase or decrease the stitch width using + and -.
Stitch positioning (26)
For straight stitches the stitch positioning icon (26)
is shown instead of the stitch width icon. Use +
to move the needle to the right and - to move the
needle to the left. For straight stitches the machine
has 37 needle positions.
It is possible to change the needle position of all
stitches that are less than 9 mm wide. Touch the
width/position toggle (11) icon to toggle between
stitch width and stitch positioning. The stitch
position can only be changed to the limit of the
maximum stitch width. Changing the stitch position
will also limit the stitch width adjustment.
Stitch length (12)
Increase or decrease the stitch length using + and -.
If lengthening a zigzag stitch or a decorative stitch,
the entire stitch will be longer. If lengthening a satin
stitch where the density can be adjusted, the entire
stitch will be longer but the density will remain the
same.
To Next Page
Loading...
