4:9
15
a b c
c
d
d
15
9
18
Sewing mode
Sensormatic free-motion (16c)
Activate to set the machine in Sensormatic free-
motion mode for presser foot 6A.
When sewing free-motion at low speed the presser
foot will raise and lower with each stitch to hold the
fabric on the needle plate while the stitch is being
formed. At higher speed, the presser foot Á oats over
the fabric while sewing.
Skipped stitches can occur if your fabric moves
up and down with the needle as you are stitching.
Lowering the presser foot height will reduce the
space between the presser foot and the fabric and
eliminate the skipped stitches.
To adjust the presser foot height in Sensormatic
free-motion mode, long touch the check box (d) and
make adjustments in the pop-up.
Note: Be careful not to reduce the presser foot height too
much. The fabric must still move freely under the presser
foot.
Sequence start position (9)
When sewing a sequence it is possible to start
sewing anywhere in the sequence. Use the arrows
(9) to step through the sequence. Read about
sequencing in chapter 5.
Zoom to all (18)
If the stitch or sequence is wider than what can be
shown on the screen, you may use the zoom to all
icon to see the whole width of the sequence.
Note: Zoom to all is only visible if the stitch or sequence
is wider than the stitch À eld.
Save options (15)
Select where to save your stitch, open the different
save options under save (15).
a) Save to Personal À les
b) Save to Personal menu
c) Save personal default stitch
Save to Personal À les (15a)
To save a stitch into your Personal À les, touch the
save icon (15) and select save to Personal À les (15a).
The icon will open a new window where you can
select where to save your stitch. You can save either
to a folder in your Personal À les or to an approved
external device.
To Next Page
Loading...
