7:4
A
A
B
Embroidery Mode - Preparations
Remove the embroidery unit
1. To store the embroidery unit in the embroidery
case, move the embroidery arm to park position
by selecting park position on the screen in either
Embroidery edit or Embroidery stitch-out.
2. Press the button at the left, underneath the
embroidery unit (A) and slide the unit to the left
to remove it.
3. The cover of the socket closes automatically.
4. Store the embroidery unit in the original
packing material, place in the soft carrying bag.
Attach the embroidey foot 6A
When embroidering, presser foot 6A is
recommended. See page 2:9 for instructions on how
to change presser foot.
To hoop the fabric
For the best embroidery results, place a layer
of stabilizer beneath the fabric. When hooping
stabilizer and fabric make sure that they are smooth
and securely hooped.
1. Open the quick release (A) on the outer hoop.
Remove the inner hoop. Place the outer hoop on
a À rm Á at surface with the screw on the lower
right. There is a small arrow in the center of the
lower edge of the hoop which will line up with
a small arrow on the inner hoop.
2. Place stabilizer and the fabric, with the right
sides facing up, on top of the outer hoop. Place
the inner hoop on top of the fabric with the
small arrow at the bottom edge.
3. Push the inner hoop À rmly into the outer hoop.
4. Close the quick release. Adjust the pressure of
the outer hoop by turning the retaining screw
(B). The fabric should be taut in the hoop for the
best results.
Note: When embroidering additional designs on the
same fabric, open the quick release, move the hoop to the
new position on the fabric and close the quick release.
When changing type of fabric, you might need to adjust
the pressure using the retaining screw. Do not force the
quick release.
To Next Page
Loading...
