4:23
Sewing mode
Common sewing pop-ups
System busy
When the machine is loading, saving, moving À les
or anything that takes time, an hour glass is shown.
Bobbin empty
When the bobbin is almost empty, the machine
stops automatically and a pop-up appears on the
screen. Replace the empty bobbin with a full one.
Note: It is possible to sew until the thread has run out.
Just continue sewing without closing the pop-up.
Check needle thread
The machine stops automatically if the needle
thread runs out or breaks. Re-thread the needle
thread, close the pop-up and start sewing again.
Remove Sensormatic buttonhole foot
The Sensormatic buttonhole foot needs to be
removed before doing any of the following:
• Sewing a stitch that is not a buttonhole.
• Sewing a buttonhole that can not be sewn with
the Sensormatic buttonhole foot.
• Sewing an adjusted buttonhole saved without
the Sensormatic buttonhole foot in your
Personal menu.
Main motor overloaded
If you are sewing on very heavy fabric or if the
machine is blocked when sewing, the main motor
can get overloaded. When the main motor and
power supply are no longer overloaded, the OK
button will be enabled. Touch OK to resume
sewing.
To Next Page
Loading...
