5:6
16
20
A
Sequencing
Zoom to all (16)
If the stitch or sequence is wider than what can be
shown on the screen, you may use the zoom to all
icon to see the whole width of the sequence.
Note: Zoom to all is only visible if the stitch or sequence
is wider than the stitch À eld.
Loading and sewing a sequence
To sew the sequence touch OK (20) in the top
right corner of the screen. The sequence will be
loaded to the mode that was active before entering
sequencing; sewing mode or Embroidery edit.
Sewing mode
In sewing mode it is possible to start sewing
anywhere in the sequence. Use the arrows (A) to
step through the sequence.
If selecting another stitch in sewing mode and then
re-opening sequencing, your sequence will remain
unchanged. Every time sequencing is closed, the
sequence will be loaded to sewing mode.
Note: If you have used directional stitches to create your
sequence and the total width of the sequence is more than
9mm, the maxi-stitch foot 8 for side motion stitches must
be used even if the machine recommends another foot.
To Next Page
Loading...
