4:5
Stitch
density -
Stitch
density +
17
13
7 8
B
A
17
Sewing mode
Stitch density (13)
The stitch density control adjusts the density (the
closeness of the satin stitches that make up the
entire stitch). The density does not affect the actual
length of the entire stitch.
Touch + to decrease the density. Touch - to increase
the density.
Note: This is often used with specialty threads and when
a less dense satin stitch is desired.
Mirroring (7 and 8)
To mirror stitches or sequences side to side touch
icon (7). For mirroring end to end touch icon (8).
Balance (17)
When sewing on special fabrics or doing a special
technique, the balance may need to be adjusted.
Start by sewing a stitch on a piece of scrap fabric.
Touch the balance icon (17) to open the balance
window. Use the + and - icons (A) to adjust the side
to side and/or forward/backward balance of the
stitch. Use the pan icons (B) to see the whole stitch.
Change the picture on the screen to match your
sewn sample. When you sew again, the balance will
be corrected.
Buttonholes can also be balanced.
To Next Page
Loading...
