Pfaff Creative Performance - Common Embroidery Stitch-Out Pop-Ups

9:11
5
Embroidery mode - stitch-out
Common Embroidery
stitch-out pop-ups
Embroidery unit calibration
When the embroidery unit is attached, a pop-up asks
you to slide off the hoop and clear the machine area
for calibrating the embroidery arm. You will also be
reminded to disengage the *%5system and attach the
embroidery presser foot.
Note: It is very important to remove the hoop, otherwise the
hoop or the embroidery unit may be damaged while calibrating.
Attach correct hoop
If the size of the hoop attached to the machine does not
match the size displayed on screen, the machine will not
embroider. You must change the hoop to the displayed
size or change the hoop setting to the hoop size attached.
To change hoop settings, re-enter Embroidery edit and go
to select hoop.
Bobbin empty - move to bobbin position?
When the bobbin is almost empty, the machine stops
automatically and a pop-up appears on the screen.
Touch cancel to remain at the current stitch position.
Touch OK to move the hoop to bobbin position. The hoop
position tab opens. Replace the empty bobbin with a full
one. Touch Current position and pull back excess needle
thread. Move a few stitches backwards using the current
stitch icons (5). Press start/stop or press your foot control
to continue embroidering.
Note: It is possible to embroider until the thread has completely
run out. Press the start/stop button to continue embroidering
without closing the bobbin empty pop-up.
Controllare il À lo dell’ago
La macchina si arresta automaticamente in caso
di esaurimento o rottura del À lo nell’ago. InÀ lare
nuovamente il À lo nell’ago, chiudere il popup, retrocedere
di qualche punto e ricominciare a ricamare.