2: Device Basics Basic Orientation
10
Connecting the CO
2
cable and Sample Line
To connect the CO
2
cable:
1 Hold the cable connector with the flat side facing the front of the Efficia DFM100, insert the
cable into the gray CO
2
port (see Figure 8) and push completely in.
2 Attach the Sample line to the sensor (see Figure 8) and then to the patient, see “Monitoring
EtCO
2
” on page 102.
Figure 8 Connecting the CO
2
Cable
Connecting a Sidestream Module
Connecting a Mainstream Module
To Next Page
Loading...