Phoenix LT4 Lane Machine Operation, Maintenance, and Parts Manual
4-40 Rev. Date: 01/22 61-900040-000
6. Insert the USB flash drive into the USB on the control box then close and latch the
oil compartment door.
7. Take note of the time, plug the machine in, and
turn the power switch on.
8. A screen similar to the one shown in Figure 4-
52 will appear on the screen while the software
is updating. There is no status bar or other
indication of the progress of the upgrade. An
update takes approximately five minutes to
install.
9. When the update has finished installing, the
Home Screen will reappear. Turn the power switch off.
10. Open the oil compartment door, remove the USB flash drive, then close and re-latch
the oil compartment door.
11. Turn the machine on and check the Tools screen to ensure that the machine has
been updated.
12. Adjust the machines programs and settings to match the settings prior to the
upgrade.
To Next Page
Loading...
Need help?
General