User Manual
E727T0005, valid for E-727
BRO, 2019-06-28
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstrasse 1, 76228 Karlsruhe, Germany Page 103 / 240
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email info@pi.ws, www.pi.ws
INFORMATION
You can permanently save the settings of the wave generator in the E-727 with the macro
functionality of the E-727 (p. 121). You can also use a startup macro to configure the wave
generator and start the output each time that the E-727 is switched on or rebooted.
The different software interfaces provided for the controller also support use of the wave
generator. Waveforms can be defined, stored and displayed in and by the software in a more user-
friendly way than in a terminal using WAV and WGO. If using the wave generator with the GCS DLL,
PIMikroMove or drivers for NI LabView software, read the descriptions in the associated software
manual first.
INFORMATION
It is recommended to use the PI Frequency Generator Tool or the PI Wave Generator Tool for
work with the wave generator (both available in PIMikroMove).
No command knowledge is necessary to work with PIMikroMove. The use of the PI Frequency
Generator Tool is described in the A000T0057 technical note. The use of the PI Wave Generator
Tool is described in the PIMikroMove manual (SM148E).
To Next Page
Loading...
Need help?
General
