User Manual
E727T0005, valid for E-727
BRO, 2019-06-28
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstrasse 1, 76228 Karlsruhe, Germany Page 11 / 240
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email info@pi.ws, www.pi.ws
b) If necessary: Click Load more results at the end of the list.
c) Click the corresponding product in the list.
7. Click the Downloads tab.
The manuals are displayed under Documentation.
8. Click the desired manual and save it to the hard disk of your PC or to a data storage medium.
Safety
Intended Use
The E-727 is a laboratory device according to DIN EN 61010-1. It is intended to be used in interior
spaces and in an environment which is free of dirt, oil and lubricants.
The E-727 is designed and intended for driving capacitive loads (e. g. piezo ceramic actuators).
The E-727 must not be used for purposes other than those named in this user manual. In
particular, the E-727 must not be used to drive ohmic or inductive loads.
The E-727 can be used for static as well as dynamic applications.
Depending on the model, capacitive sensors or strain gauge sensors or piezoresistive sensors
(semiconductor strain gauge sensors) must be used for closed-loop operation. PI stages intended
for closed-loop operation already have the corresponding sensors. Other sensors can only be used
with PI approval.
General Safety Instructions
The E-727 is built according to state-of-the-art technology and recognized safety standards.
Improper use can result in personal injury and/or damage to the E-727.
Only use the E-727 for its intended purpose, and only use it if it is in a good working order.
Read the user documentation (user manuals, Technical Notes).
Immediately eliminate any faults and malfunctions that are likely to affect safety.
The operator is responsible for the correct installation and operation of the E-727.
Install the E-727 near the power source so that the power plug can be quickly and easily
disconnected from the mains.
Use the supplied components (adapter) to connect the E-727 to the power source.
If one of the supplied components for connecting to the power source has to be replaced,
use a sufficiently dimensioned component.
Only use cables and connections that meet local safety regulations.
To Next Page
Loading...
Need help?
General
