User Manual
E727T0005, valid for E-727
BRO, 2019-06-28
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstrasse 1, 76228 Karlsruhe, Germany Page 188 / 240
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email info@pi.ws, www.pi.ws
Command Function
Gives the data recorder table rate. For the parameter concerned, see p. 67.
Reads the current setting of the data recorder table rate.
Sets the value of the Servo Loop Slew-Rate parameter, ID 0x07000200.
Reads the current value of the Servo Loop Slew-Rate parameter, ID 0x07000200.
Adds an offset to the wave generator output. For the parameter concerned, see
p. 112.
Reads the current valid offset value.
Gives the wave generator table rate. For the parameter concerned, see p. 112.
Reads the current setting of the wave generator table rate.
The following special command only changes the corresponding parameter in the nonvolatile
memory.
Command Function
Defines the default settings for communication via the RS-232 interface (baud rate;
p. 61) and TCP/IP interface (IP address, IP mask, IP start; p. 56).
For detailed command descriptions see the GCS commands manual PZ281E.
INFORMATION
The parameters listed above can also be changed with the general commands (p. 186).
To Next Page
Loading...
Need help?
General
