HUNTER-PRO Series Installation Guide 19
Figure 9. Connecting DEFENDER PIR without EOL resistor
3.1.3 Connecting a Detector using a Single EOL
Connecting N.C. detector with a single EOL resistor is done according to the next
diagrams. The tamper needs be connected to the TMPR input on the control panel’s
PCB or as a “24 hours” separate
When connecting N.O. detector, configure the zone input
accordingly (see section 5.4.1(
3.1.3.1 Connecting EOL resistor to N.C. DEFENDER PIR
Zone
() Panel
+
Detector
Figure 10. One EOL resistor
connected to N.C. detector
Figure 11. One EOL
resistor in serial to the
relay and the tamper
Figure 12. Separate
connections for the
relay and the tamper,
each with its EOL
resistor
To Next Page
Loading...
