HUNTER-PRO Series Installation Guide 31
Opt Siren Type JP5/
JP10
JP6 Parameter ‘D’ in
“General” menu
1 Speaker: Panel generates a tone. Uses
unregulated voltage
2-3 2-3 Set to “-”
2 High current self-activating bell
(protected by 1.1A thermal fuse): Uses
the panel’s battery
2-3 1-2 Set to “+”
3.6 Relay Output
The relay can be used for activating external devices (light, CCTV etc.) and is activated
response to alarm/fault, when entering relay code in the keypad and via telephone.
To program Relay Code refer to “HUNTER-PRO SERIES User Manual”. To program relay
trip time see section 5.6.2.
If the relay timer is programmed to zero, when triggered, it
remains tripped until a code is entered or the system is disarmed
3.7 OUT-1000: Local Outputs Expansion Card
OUT-1000 is an 8 TTL outputs card, used to activate peripheral devices such as CCTV,
alarm triggered lights, etc. Use the cable to connect the control panel’s EXPANTION
CARD connector to connect the OUT-1000.
Figure 28. Connecting OUT-1000 to control panel
To Next Page
Loading...
