22 HUNTER-PRO Series Installation Guide
3.2.3 Zone Doubling
The 8 onboard zones can be doubled to 16 by using different resistors, so zone #1
input is used by both zone #1 and zone #9, zone #2 input is used by both zone #2
and zone #10 etc., up to zone #16.
Zone doubling cannot be enabled if any expander is connected to the system
Control Panel
Z1 Z2 Z3
10KΩ 1/4 w
5.1KΩ 1/4 w
Z1 Z9 Z2 Z10 Z3
Z11
3.2.4 EXP-PRO UNIV
1. Connect the card to the system case, using the 2 supplied screws.
2. Use the supplied flat cable to connect the card to PCB’s Expansion Card socket
(see the following drawing)
3. To configure the EXP-PRO UNIV, refer to section 5.3.2.
Figure 17. Connecting EXP-PRO UNIV to the PCB
To Next Page
Loading...
