HUNTER-PRO Series Installation Guide 59
Code Details
AC + RESTR Mains voltage (AC) failure + Restore Code
LB + RESTR Low Battery + Restore Code
PF + RESTR Power Failure: Card voltage lower than 9 volts + Restore Code.
Low card voltage indicates AC failure and low battery
PHN + RESTR Telephone Line Failure + Restore Code
PNC Panic code
ICODE Incorrect code entered
FUS + RESTR Fail-Unsafe State: Detectors’ Voltage Fault + Restore Code
ARM System has been armed
DISAR System has been disarmed
TST System has been tested (manually, automatically, or “wake-up”).
The restore code is displayed as “RESTR” to the event’s right
5.5.6 GSM Transmitter
The following menus are available only if the enhanced menu
is enabled (see section 5.2)
Configure the GSM-200 cellular transmitter.
5.5.6.1 GSM Settings
3
ENTR ENTRNEXT
X6
Communicatio n
ENTER/NEXT/E ND
GSM Tr ansmitter
ENTER/NEXT/END
GSM Set tings
ENTER/NEXT/END
ENTR
GRTY
----
Par. Name Mark “+” to indicate that…
G GSM TX Installed GSM-200 transmitter is installed
R Use Radio ID Account Radio Account IDs will be used for GSM reports
T Auto Test Report Reports for auto-test will be sent via GSM (in
addition to PSTN)
Y GPRS Encryption The information sent via GSM will be encrypted and
sent via GPRS
If there is no radio transmitter connected to the system, ‘T’
(wireless communication) should be set to zero in the
communication format screen (see section 5.5.1.1)
To Next Page
Loading...
