Pima Hunter-Pro 832 - Key #8: Full Programming

HUNTER-PRO Series Installation Guide 75
2. ALRM output:
Configure the ALRM output so when any zone is opened, the output is tripped. To
do so, allocate the ‘Zone opened’ output type to the ALRM output.
7
ENTR
ENTR
NEXT
ENTR
O utp ut Co nfi gur.
E NTE R/NE XT/ END
AL ARM O utp ut
EN TER /NE XT/E ND
X5
P art . Fo r OU T 1
+ ++- --- ++- --+ ++
PD
-+
ENTR
Set output type
Enable partitions to
activate the output type
Set output’s polarity
& active in disarm
ON /OF F Ou tpu t
Zone Opened

3. OUT-1000 outputs
Set ‘Internal Siren’ output type to trigger output #4 on OUT-1000:
7
EN T R ENTR
NEXT
EN T R
Out pu t Co nf ig ur.
ENT ER /NE XT /EN D
OU T-1 00 0 O utp ut s
EN TE R/N EX T/E ND
Ou tp ut 4
X3
Ou tpu t 4
In ter na l S ire n
ENTR
Pa rt . F or O UT 1
++ ++ +++ ++ ++ +++ ++
PD
-+ 1
ENTR
Pick output No. 4
Set output’s output type
Set output’s partitions
S et outp ut’s p olarity & active in d isarm
Output’s No.
BACK
X3

5.10 Key #8: Full Programming
5.10.1 System Defaults
Initialize the system to factory defaults.
8 ENTR ENTR
Full Programming
ENTER/NEXT/END
System Defaults
ENTER/NEXT/END

Are you sure?
ENTER/NEXT/END
Press [ENTR] to confirm. A countdown ends with this message:
Syst.Defaulted
Press END
Press [END]
5.10.2 Local Download
8
ENTR EN TRNEXT
Full Programming
ENTER/ NEXT/END
Local Down load
ENTER/NEXT/END

Use this menu to program the HUNTER-PRO series with the COMAX upload/download
software. COMAX runs on a local computer that connects to the panel using LCL-11A
adaptor and the keypad (see section 4.1.2 and the COMAX user guide). Pressing