38 HUNTER-PRO Series Installation Guide
3.14.2 Programming the VU-20N for dual messages
Using VU-20N in HUNTER-PRO series for dual messages can be done only through
partitioning, i.e., each voice message is sent from a zone and an output allocated to a
different partition. When an alarm is triggered in a zone allocated to partition A,
‘Message 1’ is played, and when an alarm is triggered in a zone allocated to partition B,
‘Message 2’ is played.
1. Navigate to a desired output and link it to the
‘Audio control’ output type (#7)
2. Press ENTR and allocate the output to any partition,
by marking ‘+’ under that partition, and ‘-’ under
all others
3. Press ENTR to Polarity and mark ‘-’ under ‘P’
4. Repeat steps 1-3 with a second output
5. Navigate to ‘Zone responses’ (#2), pick the zone
type/s that will trigger the VU-20N ‘Message 1’ and‘
Message 2’ and mark ‘+’ under ‘M - Activate Audio’.
Make sure that the output trim time of ‘Audio
device’ is the default 60 seconds (#4)
Figure 39. Dual messages
6. For each zone, navigate to Partitions (#2) and allocate the zone to the desired
partition by marking ‘+’ (All others should be marked with ‘-’)
7. Navigate to ‘Communication options’ (#3) and mark ‘+’ under ‘V - Voice unit’
3.15 Battery
The HUNTER-PRO series has a rechargeable 12V battery. The system tests the battery
continuously.
If a test fails, the system displays battery fault and responds as
programmed in the faults responses (activating sirens, dialing the
Monitoring Station, etc.)
3.15.1 Manual Battery and Phone Line Test
To manually test the battery and phone line: Master code . If both tests
are OK, a corresponding message is displayed.
If the battery is low, a “Low Battery” message is displayed and the battery should be
replaced.
To Next Page
Loading...
