HUNTER-PRO Series Installation Guide 81
CH. 6. REMOTE CONTROL VIA TOUCH-TONE TELEPHONE
HUNTER-PRO series can be remotely controlled via any touch-tone telephone, including
a cellular. The system can be controlled in one of 2 options:
Mode A
: Basic commands, including arming and disarming (the default mode).
Mode B
: Full control, including triggering all the outputs
The entire chapter applies both when you call the system and
vice versa
6.1 Mode A
1. Dial the system’s telephone number
2. Wait for confirmation tone (a long tone followed with 2 beeps)
3. Enter Master Code
4. Wait for a status tone:
Continuous: The system is disarmed
Beeps: The system is armed
The system will not respond to commands while playing the
confirmation tone. It is important to wait until the confirmation
tone is over before pressing any telephone key
5. Press a key according to the next table. The system confirms the command
with 2 short beeps.
key Function
Turn off the external siren and stop the dialer from calling any other no.
Arm the system
Disarm the system
Arm the system to ‘Home 1’ mode
Trigger the onboard relay
Stop triggering the onboard relay
Arm the system to ‘Home 2’ mode
Listen in for one minute (available only with MIC-200). To extend listen in
time (in one minute), press
again as needed
While the system is engaged in remote session, the following message is displayed on
all connected keypads: “Other keypad in use”.
If the system does not receive any command for a period of 60 seconds, it shall
disconnect and return to normal mode. The system will remain in standby (displaying
“Other keypad in use”) for another 60 seconds, before returning to normal mode.
To Next Page
Loading...
