HUNTER-PRO Series Installation Guide 7
5. Install this product in a protected location where no one can trip over any line or power cord.
Protect cords from damage or abrasion.
6. Disconnect all sources of power supply before proceeding with the installation. Pay
attention: do not install low voltage wires near by AC power wires they should be separated.
7. Connect the AC transformer output to the terminal block on the control panel as marked.
8. Connect the AC line cord to line power terminals as marked. (GND; N; L)
1.2 The Hunter-Pro Series Main Features
! Hybrid system with 32/96/144 zones, of which 24/32 could be wireless
! Support in partitioning & zone doubling
! Outgoing SMS over PSTN or GSM
! Remote control of the system, including outputs, via touchtone telephone
! Full supervision data of wireless detectors (include. low battery, tamper)
! Comprehensive zone tests for flawless installation: Walk Test, Soak Test, etc.
! Several options for displaying the system status in LCD keypads
! 4 subscriber and SMS numbers with optional voice message and microphone
! 4 monitoring stations telephone numbers
! Integrated communicator for telephone, radio, GSM/GPRS and IP network
! Supports split and double reporting
!
Prevention of burglary setup: limited bypass time, zone bypassing authorization,
pre-alarm and more
! Continuous battery and telephone line checks
! LED keypad support
! Filtering of reoccurring faults: a fault (jamming, mains etc.) occurring 5 times in
one hour will not be reported any more, before an hour passes with the fault not
occurring again or the system is either armed or disarmed
! Memory log of up to 410/500/999 events with time and username
1.3 Terms and Abbreviations
Enabled User Code: A code enabled (by the technician) to enter the user menu
LCD Zone Numbers:
The 1-16 & 17-32 numbers printed above and below the LCD
display window; Indicating the first 32 zones’ numbers
MS: Monitoring Station
To Next Page
Loading...
