88 HUNTER-PRO Series Installation Guide
7.3.6 Auto-Arming & Auto-Arming by Partition
Make sure that:
1. Auto-arming start time is programmed (see HUNTER-PRO series User guide).
2. System time is correct.
3. The desired partition is programmed as so.
7.3.7 Violating a Zone does not Set-off the Alarm
Make sure that:
1. The zone is neither temporarily nor permanently bypassed.
2. The zone is programmed to the desired responses (sirens, relay, etc.)
3. The zone is programmed to only one partition.
4. The detectors are in order and installed correctly.
5. Zone sensitivity is correct.
6. Zone conditioning is correct.
7. Zone no. of pulses is correct.
8. Zone is not programmed as soak zone.
7.4 MS Report Formats & Codes
7.4.1 Pulse Formats
Name Rate (pps) ACK (Hz) Error Control ID Event A B
3 - 1 162 1
3 - 2 163 1
4 - 1 162 129
Double Round
4 - 2 163 129
3 - 1 162 65
3 - 2 163 65
4 - 1 162 193
1400
Checksum
4 - 2 163 193
3 - 1 162 17
3 - 2 163 17
4 - 1 162 145
Double Round
4 - 2 163 145
3 - 1 162 81
3 - 2 163 81
4 - 1 162 209
Ademco
Slow
10
2300
Checksum
4 - 2 163 209
To Next Page
Loading...
