54 HUNTER-PRO Series Installation Guide
5.5 Key #3: Communication Parameters
5.5.1 Monitoring Station #1 Options
5.5.1.1 Protocol
3
EN TR ENTR
Communication
ENTER/NEXT/END
MS 1 Options
ENTER/NEXT/END
MS 1 P ro to c ol
0 230 T=0
AB
Set MS1 PSTN protocol and radio station no. ‘A’ & ‘B’ (above) determine the PSTN
protocol (see the matching columns in the codes table, section 7.4) and ‘T’ determines
the radio station number (which is determined by the MS).
1. MS 1 is programmed to use ContactID by default
2. If no Radio receiver is installed, do not change the default T=0
value
5.5.1.2 MS1 Reports
AA12PFDMOLTWIR
+++++++++++-++1
Set the events that will be reported to MS1:
Par. Alarm/Event
A All alarms
A Anti-Mask
1 Special Burglary 1
2 Special Burglary 2
P Panic
F Fire
D Duress/Hold-up
M Medical
O Remote open/close (by Phone)
L Failures
T Tests
W Remote Test: When the system is armed, in response to 2 telephone
rings and a hang up the system sends a test report to the MS
I Technician code entered
R Zone Open/Close reports are sent only via the radio
To save, press [ENTR]
To Next Page
Loading...
