HUNTER-PRO Series Installation Guide 35
3.11 TRV/TRU-100 Long Range Radio Transmitters
3.11.1 Mounting Guidelines
Following these guidelines will minimize RF interference:
Do not mount the Panel close to a metal wall or ceiling
Make sure you leave enough space for the atenna between the metal box and
the ceiling
Install the antenna at a distance from the Control Panel’s wiring
Mount the antenna after you complete all other installations
Make sure the antenna is not folded and is vertical
Close the HUNTER-PRO SERIES metal box when performing transmission tests
3.11.2 Connecting the Transmitter
The TRV/TRU-100 can transmit in 2 frequencies
1. Mount the HUNTER-PRO SERIES metal box on a stable surface/ wall
2. Screw the transmitter’s 4 screws (at the base) to the system box. Make sure
the screws are tightened; else, the transmitter’s range can be reduced.
3. Connect the antenna to the transmitter. Make sure the antenna is straight.
4. Make sure the 5-pin cable is connected to the transmitter’s Molex (named: “To
the system” on the transmitter’s sticker.)
5. Connect the other end of the 5-pin cable to the male Molex, placed on the
Control Panel’s upper left side (named “Transmitter” on the Control Panel.)
To use the second frequency only:
Follow the pervious 1 to 5 instructions, and then:
1. Connect the 2-pin cable to the transmitter’s F2 Molex (named F2 on the
transmitter’s sticker.)
2. Connect the other end of the 2-pin cable to the control panel depends on the
desired transmitter operation:
To constantly work with the second frequency:
Connect it to (-) output on the Control Panel.
To work with 2 frequencies according to event type:
1. Connect it to one of the system’s outputs, such as ALARM or ON/OFF to one of the
PGM outputs: AL/ON/OFF/RELAY.
2. Program these outputs in “Outputs” menu (see section 5.9). The related
parameters need to be programmed in “Communication Configuration” menu (see
section 5.5.4).
To Next Page
Loading...
