6 HUNTER-PRO Series Installation Guide
CH. 1. INTRODUCTION
This guide provides the installation, wiring and programming instructions for PIMA’s
intruder alarm series, Hunter-Pro 832, 896 & 8144 for 8-144 zones.
PIMA is enhancing its successful HUNTER-PRO 896 with 2 new versions: Hunter-Pro
832 and Hunter-Pro 8144 for 32 & 144 zones.
The Hunter-Pro 832 replaces the Hunter-Pro 32.
The Hunter-Pro series is based on the HUNTER-PRO 896 circuit and menus, with the
only difference being the capacity, i.e. the overall number of zones, users and
connected expanders (See the next table).
The HUNTER-PRO series is secured against radio-frequency (RF) interferences and
electro-magnetic interferences (EMI).
1.1 Comparison table between the Hunter-Pro
series models
Panel Model
Feature 832 896 8144
Zones 32 96 144
Users 32 96 144
Partitions 16 16 16
Wireless zones 24 32 32
Key fobs 24 24 24
Memory total 410 500 999
Memory non-volatile 128 250 512
SAFETY INSTRUCTIONS
Your HUNTER-PRO 832/896/8144 Alarm System has been registered in accordance with
EN60950 and its rules. EN 60950 requires us to advise you the following information:
1. In this alarm system exist hazards of fire and electric shock. To reduce the risk of fire or
electric shock, do not expose this alarm system to rain or moisture. Pay attention: Telephone
cords could be a good conductor for lightings energy.
2. Do not open the door of the alarm system. Dangerous high voltages are present inside of the
enclosure. Refer servicing to qualified personnel only. 3. This alarm system should be used
with 230VAC/110VAC, 50/60Hz, protected by anti-electric shock breaker. To prevent
electric shocks and fire hazards, do NOT use any other power source.
4. Do not spill liquid of any kind onto the unit. If liquid is accidentally spilled onto the unit,
immediately consult a qualified service.
To Next Page
Loading...
