HUNTER-PRO Series Installation Guide 47
CH. 5. PROGRAMMING THE SYSTEM
5.1 The Technician Menu
5.1.1 The Keypad Keys Functions
The Hunter-Pro series technician menu is made of 11 sub-menus, all accessed and
programmed with the LCD keypad keys. The keys and sub-menus are:
Key Functions Page
[1] System Installation: Expanders, Keypads Etc. 48
[2] Zones: Types, Responses, Names, Partitions Etc. 50
[3] Communication: MS1 Options, Subscriber Numbers,
Communication Options, Radio Report Codes Etc.
54
[4] Timers: Entry/Exit Delay, Outputs Times, Reports
Delays, Soak Test Days Etc.
66
[5] General Parameters 69
[6] System Responses: Mains Fault, Battery Fault Etc. 70
[7] Outputs Configurations 71
[8] Full Programming (Reset), Local And Fast Download 75
[9] Installer Code Change 76
[*] Fast Programming 76
[0] Tests 76
5.1.2 Navigating the Menu
Navigating the menu is easy: go to the next level or Save by pressing [ENTER], go
forward and backward by pressing [NEXT] and [BACK], exit without saving or go one
level up by pressing [END].
5.2 Enhanced Communication Menu
The HUNTER-PRO 832/896/8144 has an enhanced communication menu with various
parameters. By default, this menu is not visible, because most installations do not
require changing the defaults for these parameters, which necessitates knowledge in
communication networks to set them.
To make the enhanced menu visible, either mark “+” under ‘P’ in the first “General
Parameters” screen (see section 5.7.1) or press [
*
] for 3 seconds in the first screen of
the Communication menu (key #3).
To Next Page
Loading...
