44 HUNTER-PRO Series Installation Guide
4.1.5 Navigating through the menu
[NEXT] / [BACK]: Backward/Forward keys. Press these keys to navigate between
screens/ options/parameters
[ENTR]: Selection/Conformation key
[END]: Exit/End key: Return to the previous screen without saving
[#]: Reset/Erase/Change status key (“-” to “+” and vice-versa)
4.2 Default Codes
The system default codes are:
Master Code 5555
Technician Code 1234
4.3 User Menu
There are 3 ways to enter the user menu, where parameters like date & time, dialer
numbers and codes are programmed:
1. Using Master code:
User Menu
Choose 1,2..
MASTER
COD E
9
2. Using enabled (see
notes below) User
code:
User Menu
Choose 1,2..
USER
CODE
9
3. Using Technician
code (see notes
below)
TECHN ICIAN
CODE
0
9
User Menu
Choose 1,2..
1. Only enabled user code can access the user menu. To enable it,
mark “+” under “M” in “General Parameters” menu (see section
5.7). As a result, actions such as arming and disarming cannot
be activated directly, but by entering the user code first and
then pressing the desired key.
2. User Code has no authorization to change Master Code.
3. When accessing the user menu from within the technician menu,
changing codes is disabled.
To Next Page
Loading...
