Planmeca ProMax User Manual

Planmeca ProMax 3D Max with ProTouch 3
SYMBOLS ON PRODUCT LABELS
User’s Manual
3 SYMBOLS ON PRODUCT LABELS
CE marking according to European standards
(Directive 93/42/EEC)
CSA marking according to Canadian and US standards
(Standards C 22.2 No. 601.1 and UL60601-1)
Date of manufacture (Standard ISO 15223-1)
Attention, consult accompanying documents
(Standard IEC 60601-1)
Type B applied part (Standard IEC 60601-1)
Separate collection for electrical and electronic equipment
(Directive 2002/96/EC WEEE)
Alternating current (Standard IEC 60417)
Electrostatic sensitive device (Standard IEC 60417)
4 SAFETY PRECAUTIONS
CAUTION FOR US USERS:
Federal law restricts this device to sale by or
on the order of a health care professional.
CAUTION This X-ray unit may be dangerous to both
patient and operator unless safe exposure
values are used and correct operating
procedures are observed.
CAUTION The patient positioning lights are laser
lights. Do not stare into the laser beam.
CAUTION If an exposure is interrupted (e.g. exposure
button is released or emergency stop button
activated), the patient must be guided away

Planmeca ProMax Specifications

General

Category	Medical Equipment
Type	Cone Beam Computed Tomography (CBCT) System
Software	Planmeca Romexis
Imaging Modes	CBCT
Imaging Modalities	2D Panoramic
X-ray Generator	High Frequency Generator
Focal Spot Size	0.5 mm
X-ray Tube Voltage	60-90 kV
Exposure Time	Varies depending on imaging mode and parameters
Dimensions	Varies significantly depending on model and configuration
Weight	Varies significantly depending on model and configuration
Power Requirements	50/60 Hz
Patient Positioning	seated