Planmeca ProMax - 3 D Patient Exposure Procedures; Preparing the X-ray System for Exposure

3D PATIENT EXPOSURE
18 Planmeca ProMax 3D Max with ProTouch
User’s Manual
8 3D PATIENT EXPOSURE
8.1 Preparing X-ray system
8.1.1 Attaching patient supports
NOTE The available head supports are shown in section 6.3.1
“Head supports (A or B)” on page 9.
Attaching support bars
Insert the support bars into the holes in the patient
support table and secure them in position by tightening
the locking knobs.
NOTE Ensure that you insert the support bars the right way
round.
ProMax_5_2.eps
Support bars
Patient support table
Locking
knobs
ProMax_2_2.eps