3.40
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
6. Remove ignition coils
t
.
7. Snip the electrical tie downs
y
and leave the fir trees
in the valve cover.
8. Using compressed air, blow out the vent fitting cavity
to remove any dust or debris prior to removing the
valve cover.
9. Remove valve cover fasteners
u
. Remove valve
cover and gasket
i
.
CRANKSHAFT HARMONIC DAMPER
REMOVAL
1. Park vehicle on a flat surface.
2. Remove the cargo box.
3. Remove alternator belt cover.
4. Using special tool PU-52810 to hold the harmonic
damper, remove the harmonic damper fastener
t
and washer.
5. Using the recommended 3–jaw puller, remove the
harmonic damper
y
. Clean and inspect the harmonic
damper prior to installation. Refer to Harmonic
Damper Cleaning and Inspection page 3.66
NOTICE
Recommended 3-Jaw puller:
OTC 6667
IMPORTANT
Place the 3–jaw puller on the inside arms of the damper
during removal as shown. NEVER place force on the
outside of the harmonic damper as damage will occur.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
