9
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
9.21
4. install a new retaining ring
e
.
5. Measure the installed end gap of the retaining ring to
ensure it is fully seated and within specification.
MEASUREMENT
Retaining Ring Installed End Gap:
No greater than 5 mm
6. If the installed end gap of the retaining ring exceeds 5
mm, remove retaining ring, inspect and clean groove
as necessary. Install a NEW retaining ring and repeat
measurement.
7. Repeat the ball joint service procedure for any
additional control arm ball joint replacements.
8. Refer to upper/lower control arm replacement for
installation procedure and applicable torque
specifications.
STEERING / SUSPENSION
To Next Page
Loading...
Need help?
General
