USER MANUAL
Rev. A 6 May 2020
CLEANING
The only required maintenance is cleaning the System Electronics Unit (SEU), Sources, Sensors and Cables. If the
instrument requires cleaning:
1. Remove power from the SEU.
2. Clean the external surfaces of the SEU, Cables and external shells of the Sources and Sensors with a soft
cloth dampened with a mixture of mild detergent and water.
Make sure that the SEU is completely dry before reconnecting it to a power source.
STERILIZATION
No component of VIPER™ is provided sterilized. Only the sensors and TX1 Source can be sterilized and only with
ETO Gas. There is no known limit on the number of cycles.
STORAGE AND TRANSPORT
Temperature -10C to +50C
Relative Humidity 10% to 90% non-condensing
Atmospheric Pressure 50kPa to 106kPa
DISPOSAL
VIPER™ components are considered electronic waste and should be disposed of in accordance with local
ordinances.
To Next Page
Loading...