Poly VVX D230 - Page 81

Parameter Reference
80
X_RingProfile Selects a Ring Profile to ring the handset for incoming calls
on this service that are routed to it. The ringing pattern is
taken from the given profile. Choices are A or B.
A
X_CodecProfile Selects a Codec Profile for all calls on this service. Choices
are A or B.
A
X_InboundCallRoute Routing rule for directing incoming calls on this service. The
default rule is to send all incoming calls to the handset.
See the Call Routing chapter for a description of the
syntaxes to specify this parameter.
DT1
X_RegisterEnable Enables registration for this line. If set to True, the handset
sends periodic SIP REGISTER to the service provider
according to the settings in the ITSP Profile. Otherwise, the
handset doesn’t send any SIP REGISTER for the service.
True
X_AcceptSipFromRegistrarO
nly
Accept SIP packets coming from the current registrar IP
address only.
False
X_NoRegNoCall Enables this option to disallow incoming and outgoing calls
if registration with the service provider isn’t successful.
False
X_KeepAliveEnable Enables sending keep alive message. If set to True, the
handset sends periodic keep-alive messages to the same
server where a REGISTER request would be sent. The
content of this message is the ASCII string
keep-alive\r\n.
False
X_KeepAliveExpires Keep alive period in seconds. 15
X_KeepAliveMsgType The type of keep alive messages to send out periodically if
keep-alive is enabled. Choice of:
• keep-alive: The string keep-alive
• empty: A blank line
• stun: A standard STUN binding request. The handset
uses the binding response to form its contact address for
REGISTRATION
• custom: use the value of X_CustomKeepAliveMsg
• options: A SIP OPTIONS message
• notify: A SIP NOTIFY message
keep-alive
SPn Services (n = 1, 2, 3, 4, 5, 6, 7, 8) Settings
Parameter Description Default Setting