100
Material Safety Data Sheets (MSDS)
13.12Lithium battery safety precautions
The lithium battery on the microprocessor PCB does not constitute a serious hazard providing the following
instructions are observed:
NEVER:
• Attempt to recharge the battery.
• Crush, puncture, open or dismantle the battery.
• Store or operate equipment above the temperature specified.
• Short-circuit the battery.
• Dispose of the battery in a fire.
• Try to repair faults on the control PCB
In the event of a PCB fault or battery leakage:
ALWAYS:
• Wear suitable protective clothing.
• Remove the equipment to a well ventilated area.
• Contact your local agent.
• Refer to Health and Safety Notes on Lithium batteries.
To Next Page
Loading...