Powell BriteSpot Plus - S Cope; P Urpose; A Pproval and Ertifications; Safety Information

Powered by Safety
®
2
General Information
01.4IB.48041
BriteSpot® Plus
A. Scope
The information in this instruction bulletin
describes the following fiber-optic temperature
monitoring system:
• BriteSpot® Plus
B. purpoSe
The information in this instruction bulletin
is intended to provide details required to
properly operate and maintain the
fiber-optic temperature monitoring system
described in Ch 1 General Information,
A. Scope.
This instruction bulletin provides:
1. Safety guidelines
2. General descriptions of the operation and
maintenance of the BriteSpot temperature
monitoring system
3. Information for ordering renewal parts
4. Illustrations, photographs, and description
of the BriteSpot Plus temperature
monitoring system
The illustrations contained in this document
may not represent the exact construction
details each BriteSpot Plus installation. The
illustrations in this document are provided
as general information to aid in showing
component locations.
All illustrations and photos are shown using
deenergized equipment.
Follow the appropriate safety precautions
while handling any of the equipment. Failure
to do so may result in death or serious injury.
!
WARNING
c. ApprovAl And certificAtionS
1) Safety Information
BriteSpot Plus temperature monitoring
system is designed and tested to comply
with IEC 61010.
2) FCC Statement
This equipment has been tested and found
to comply with the limits for a Class A
digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in an industrial
installation. This equipment generates and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation.
3) EMC Directive
The BriteSpot Plus Conversion Model has
been designed and tested to meet the
European Electromagnetic Compatibility
Directive (EMC Directive, 2014/30/EU). The
Declaration of Conformity for BriteSpot Plus
lists the specific standards to which the
BriteSpot Plus system was tested.
Immunity of the BriteSpot Plus Conversion
Module was tested for use in Power Station
and Substation Environments according to
IEC61000-6-5-2015.