powersoft X8 - Troubleshooting Diagrams; Power Supply Faults Troubleshooting

INDEX
33
X8 | SERVICE MANUAL
19. Troubleshooting diagrams
Fault in the Power Supply
Fault in the Power Supply
Check the connection to the mains, wether Single, Dual, or Three phase.
Check the Mains Fuses
Check the absorption of
the PSU in DC (by itself)
Reassemble the PSU
Reassemble the PSU
Replace the
Slot ETH Board
Contact the
Powersoft
Service Team
Contact the
Powersoft
Service Team
Contact the
Powersoft
Service Team
Update the unit’s
Firware via Armonia
or through the USB
Pen Drive procedure
Contact the
Powersoft
Service Team
Contact the
Powersoft
Service Team
Contact the
Powersoft
Service Team
Replace all fuses and
check the absorption of the
PSU in DC (by itself)
Remove the Slot ETH
Board and repeat the
absorption test on the PSU
(mounted on the unit)
Unplug the S05 and S06
Flat Cables and check
the absorption of the PSU
(mounted on the unit)
OK
PASS
PASS
FAIL
PASS
PASS
FAIL
FAIL
OPEN
FAIL