powersoft X8 User Manual

30
X8 | SERVICE MANUAL
16. Reworking Screws
Under certain circumstances it may happen that one or
more screws come loose.
Remove all micromatches from the top of the amp (Fig.
44).
Remove the screws highlighted on (Fig. 45) by means of
a T20 Torx Screwdriver, extract them by means of a set
of long needled pliers.
Place a dab of Loctite 2400 on the tip of each screw, then
set them back to their original position. (Fig. 46)
The easiest way to do so is by using the long needled
pliers to set the screws loosely at rst, and ultimately
tightening them with mild force using the T20 Torx
screwdriver.
Place a dab of Loctite 2400 on the tip of each column,
then set them back to their original position. (Fig. 48)
The easiest way to do so is by using the long needled
pliers to set the column loosely at rst, and ultimately
tightening them with mild force using the M7 Socketed
screwdriver.
Remove the columns with a combination of a M7
socketed screwdriver and a set of long needled pliers.
(Fig. 47)
Reset all micromatch connections.
(Fig. 44)
(Fig. 45)
(Fig. 46)
(Fig. 47)
(Fig. 48)
INDEX

powersoft X8 Specifications

General

Channels	8
Signal to Noise Ratio	> 112 dB
Damping Factor	> 5000
Power Supply	Universal switching power supply (100-240V, 50/60Hz)
Networking	Ethernet
DSP	Yes, with FIR filters
Load Impedance	4Ω, 8Ω
Input Impedance	20 kΩ balanced
Cooling System	Variable speed fan
Frequency Response	5 Hz - 30 kHz