powersoft X8 - PWS Fan Failure; Firmware Issue - Versions Prior to 1.7.6.30

INDEX
35
X8 | SERVICE MANUAL
PWS Fan Failure
Firmware Issue - versions prior to 1.7.6.30
Faulty connector
- contact the
Powersoft’s Service
Team
Replace the PWS Fan
Contact the
Powersoft
Service Team
Check the PWS Fan’s
viability
Replace thre DIGI+ADLINK
Boards
Unplug and plug the PWS
Fan’s connector and switch
the unit on
Perform the SD Card
Recovery procedure and
turn the unit on
OK
PASS
OK
FAIL
FAIL
FAIL
Resolved
Update the unit’s
Firware via Armonia
or through the USB
Pen Drive procedure
Update the unit’s
Firware via Armonia
or through the USB
Pen Drive procedure