This chapter describes how to install the UPS manufacturer’s batteryThis chapter describes how to install the UPS manufacturer’s battery
cabinets. Two models are available, one in a 610 mm wide cabinet and onecabinets. Two models are available, one in a 610 mm wide cabinet and one
in a
616
mm wide cabinet (referred to in this chapter as the
Type
1
baffery and thein a
616
mm wide cabinet (referred to in this chapter as the
Type
1
baffery and the
Type
2 baffery. respectively).
Type
2 baffery. respectively).
Important Safety Instructions
The installation of battery cabinets should be performed or supervised by
personnel knowledgeable of batteries and their associated precautions. Keep
unauthorized personnel away from battery cabinets.
Observe these precautions when working on or around battery cabinets:
l
Remove watches, rings, or other metal objects.
l
Use tools wlth insulated handles.
l
Wear rubber gloves and boots.
l
00 not lay tools or metal parts on top of batteries or battery cabinets.
l
Disconnect the charging source prior to connecting or disconnecting
terminals.
l
Determine if the battery is inadvertentfy grounded. If it is, remove the
source of the ground. Contact with any part of a grounded battery can
result in electrical shock. The likelihood of such shock will be reduced if
such grounds are removed during installation and maintenance.
i
When replacing batteries, use the same number of sealed, lead-acid
batteries.
l
Proper disposal of batteries is required. Refer to your local codes
for
disposal requirements.
CAUTION:
:
00
not dispose
of
battery or
batterfee
in a fire. The
battery
may
CAUTION:
00 not open or mutilate the battery or batteries.
Released
eh?drOl~
is
’
harmful to the skin and eyes, and may be toxic.
CAUTION:
’
A bstterv can cause electrfcal shock, bum from high short-circuit
I
current,or fire. Observe proper precautions.
Powwware
Plus
80
UPS installation Manual
27
To Next Page
Loading...
