Powerware Plus 80 - Options and Accessories

II
Options and Accessories
Contact your sales representative for information about any of these available options:
I
I
I
~1
I
I
I.
I
I
I
I
I
I
I
I0
Battery
You can enhance the protection provided by your UPS with one or more backup battery
supplies equipped with sealed lead-acid, maintenancsfree batteries in a matching cabinet.
Each battery cabinet contains individual modular battery trays and a battery circuit breaker,
Several battery capacities are available.
The UPS battery cabinets can be parallelled; you can increase your battery backup time by
adding battery cabinets to your UPS system. Your UPS system can support up to four (4)
battery cabinets.
External Battery Disconnect
An optional DC circuit breaker endosed in a walhnounted box adjacent to the UPS
provides a manual means of disconnecting a battery that is located remotely from the UPS.
This option is described further on page 2.5 of “Using Features and Options.’
Power Distribution Module (available for N-W American vonsgm onty)
An optional output power disbibtion mooWe (PDM) is available to distribute the output
power of the UPS to your crftfoal load. The PDM cabinet has two panefs, each containing
42 poles for breaker switches you can assign with flexfbilii to meet the needs of your
facility.
Each panel is controffed by one 225 amp feeder breaker The PD$f is enclosed in
a separate cabinet that matches the UPS.
Upgrade Capability
The UPS is available in various output power ratings in both 50 and 60 Hz models. lf your
power requirements increase, you can upgrade your UPS system to provide more output
power with a minimum impact on your facflii.
Remote Monitor Panels
An optional Remote Monifor Pane/ (RMP) contains backfii status indicators and a local
horn, allowing you to monkor the operational status and alarm condition of the UPS from
virtually any location within your facility. You can install multiple RMR at remote locations
to increase your monltorfng capabiflles. This option is described further on page 32 of
“Using Features and Options.’
Relay Interface Module
An optional relay intwface module uses relay contact closures to indicate the operating
status and alarm condllon of the UPS system. The module uses a serial interface line and
may support up to eight crftlcaf loads. This option is described further on page 35 of
“Using Features and Options.’
Isolation lhmsfomer
An optional voftage-stepping i&u7 isolation @arrsformer provides an isolated input to the
rectifier for applications that require a DC link that is not ground referenced. The
transformer is contained in a matching cabinet
Cosmetic Sides
The UPS and optional component cabinets are designed to line up and match in styfe and
color. As an option, you can cover the standard bfack finish of the cabinets wfth cosmebc
sides.
I
6 Powerware Plus 80 UPS OperatMs Manual