Powtran PI9000 series - Page 112

Chapter 5 Function parameter
106
AI1 input filter time is used to set AI1 software filter time, When the on-site analog
quantity is easily interfered, please increase the filter time to stabilize the detected analog
quantity, but the greater filter time, the slower analog detection response, the proper setting
method depends on the actual application.
In the different applications, the 100.0% of analog setting vary from the meaning of its
corresponding nominal value, please refer to the description of each application for details.
The two legends are for two typical settings.
F1.16
Minimum input value
for AI curve 2
0.00V to F1.18
0.00V
☆
F1.17
Minimum input
setting for AI curve 2
-100.00% to 100.0%
0.0%
☆
F1.18
Maximum input for AI
curve 2
F1.16 to 10.00V
10.00V
☆
F1.19
Maximum input
setting for AI curve 2
-100.00% to 100.0%
100.0%
☆
For the function and use of curve 2, please refer to the description of curve 1.
100%
0V(0mA)
10V(20mA)
A1
100%
Corresponding setup
0V(0mA)
10V(20mA)
A1
-100%
Relationship between analog reference and set amount
（Frequency, torque）
Corresponding setup
（Frequency，torque）