Precisa 360 - Balance Disassembly

360 Repairs
34
2.2 Opening the balance
2.2.1 Opening the balance
1. Disconnect the balance from the mains (unplug the power adapter).
2. Remove the windshield, the protective ring, the weighing pan and the pan holder.
3. Unscrew the 3 screws on the balance's top using a No. 4 screwdriver (2 screws cyl. Phillips
M4x25 above the display and 1 screw cyl. slot M4x12 nearby the bubble level).
4. Slightly raise the housing's top.
5. Disconnect the membrane keypad ribbon cable from the main board.
2.2.2 Opening the IP65 balance
1. Disconnect the balance from the mains (unplug the power adapter).
2. Remove the windshield, the protective ring, the weighing pan and the pan holder.
3. Unscrew the 3 screws IP56 with a No. 1 screwdriver and remove the clamping ring.
4. Unscrew the 3 screws on the balance's top (2 screws cyl. Phillips M4x25 above the display and 1
screw cyl. slot M4x12 nearby the bubble level) and the 2 screws cyl. countersunk M4x12 on the
balance's bottom using a No. 4 screwdriver.
5. Slightly raise the housing's top. Take care of the sealing!
6. Disconnect the membrane keypad ribbon cable from the main board.
Clamping ring
2 Screws cyl.
countersunk M4x14
3 Screws IP65