360 Adjustments
63
3.15 Error messages
3.15.1 Operating errors; Error disappears by correct use or application
Code Cause Remedy
1 Invalid firmware Load right firmware
3 Load too small Use higher load
4 Wrong anti theft code Enter right code
5 7 times consecutively wrong anti theft code Enter unlock code,
contact service
8 Zero point out of range Repeat linearisation
9.0 Bad adjustment factor Repeat adjustment
9.1 Zero point deviation exceeded Repeat adjustment
9.2 Deviation of internal reference weight exceeded Repeat adjustment
9.3 Bad adjustment factor Repeat adjustment
30 No internal reference weight Acknowledge with TARE
Adjust internal reference weight
31 No external reference weight Acknowledge with TARE
Adjust external reference weight
47 Too much values Record less values
48 Not the pristine unit Set to the pristine unit
49 Too few values Record more values
53 Values out of the ± 50% range Place loads within the range
60 Value being below the converter range
61 Value exceeding the converter range
3.15.2 Fatal errors; Balance stays still, error remediable in service mode
Code Cause Remedy
10 No linearity values Repeat linearisation
11 No adjustment factors Repeat adjustment
21 No SCS temperature compensation values Contact service
22 No temperature compensation values Contact service
23 No SCS temperature non-linearity compensation values Contact service
3.15.3 Hardware errors; Balance stays still
Code Cause Remedy
14 Compatibility conflict Contact service
16 Broken internal RAM Exchange the µ-controller
17 Broken external RAM Exchange the RAM
18.1 Wrong firmware checksum Load the right firmware
Exchange the flash memory
18.2 No approved firmware in an approved balance Load the right firmware
Exchange the flash memory
18.9 Wrong µ-controller firmware checksum Exchange the µ-controller
19 Compatibility conflict Contact service
20 Erroneous temperature measurement Check floating sensor connections
To Next Page
Loading...
