10 Accessories
_____________________________________________________________________________________________________________________________________
10-1
10 Accessories
10.1 Adaptercard (3110)
The adaptercard can be connected externally to the 50-wire Sub-D connector on the
rear of the 5017 when it is equipped with a scanner (5017SC). This card contains
screw terminals for the incoming wires and so it is useful when you need to change
the configurations of sources being scanned.
Two adaptercards are required for connecting all 80 channels.
Dimensions: approx.. 70 mm x 110 mm
Figure: Adaptercard 3110 for scanner input
Warning:
Voltages
greater than 40V to ground should not
be connected to the
adaptercard because the screw terminals are not protected against human
touch.
To Next Page
Loading...