Error Messages
_____________________________________________________________________________________________________________________________________
4-24
4.12 Error Messages
Overflow Measuring range overflow
Sensor? Resistance of the sensor overshoots/undershoots the
defined range
Div/0 Division by zero in a mathematical function
Br. wires Open source line in 4-wire resistance measurement
Offset too high Offset too large after pressing the zero key
Polarity? Ω/4: Source or Sense are not connected with the right
polarity
Cal. Error Calibration error
reading too low Measurement reading too small
value too low Value too small
value too high Value too large
not mathematics Not for mathematics
not temperature Not for temperature measurement
Scanner Mode? Scanner mode unsuitable
Front Input Only Only at front sockets (e.g. current measurement)
invalid PIN Invalid PIN number for calibration
To Next Page
Loading...