Prema DMM 5017 - Preselecting the Command Set for Remote Control

4 Manual Operation
_____________________________________________________________________________________________________________________________________
4-19
Table: Setting the RS232 interface
The possible handshake modes for the RS232 interface are:
• Xon / Xoff
• RTS / CTS (needs a special cable, see ‘Accessories’ No. 3017)
• no Handshake
Preselecting the Command Set for Remote Control
The 5017 can be remoted with different command sets:
• 5017
• 6048 / 6047
• 6001 / 5001 / 4001 ( 6½ digit)
Keypress Display / Action
1.
MENU
-
IN KEY
'HYLFH
If this display does not appear, press the
Ø
-
KEY
until
it does appear.
2.
MENU
-
IN KEY
,QWHUIDFH
If this display does not appear, press the
×Ø
-
KEYS
until
it does appear.
3.
MENU
-
IN KEY
&RPPDQG6HW
The command set can be with the
MENU
-
IN KEY
.
4.
MENU
-
IN KEY

Select the command set and then press the
MENU
-
IN KEY
to confirm.
5.
MENU
-
OUT KEY
Takes over the entry and steps up one menu level higher. Press
repeatedly to reach the measurement reading display.
Table: Setting the command set
See chapter ‘Remote Control’ for more information.