Prema DMM 5017 - Setting the Scanner Mode

4 Manual Operation
_____________________________________________________________________________________________________________________________________
4-23
Setting the Scanner Mode
Keypress Display / Action
1.
MENU
-
IN KEY
'HYLFH
If this display does not appear, press the
Ø
-
KEY
until
it does appear.
2.
MENU
-
IN KEY
6FDQQHU
If this display does not appear, press the
×Ø
-
KEYS
until
it does appear.
3.
MENU
-
IN KEY
SROH&+
Select the desired mode with the
×Ø
-
KEYS
.
4.
MENU
-
IN KEY
SROH&+
Activates the selected mode.
5.
MENU
-
OUT KEY
Takes over the entry and then steps up one menu level higher. Press
repeatedly to reach the measurement reading display.
Table: Setting the scanner mode
The following scanner modes can be set:
• 4-pole, 20 channels
• 2-pole, 40 channels
• 1-pole, 80 channels
The pinout of the 50-pole Sub-D plug connector of the measuring points scanner is
contained in chapter "Technical Specifications".