PRG Mbox - Page 28

18
MBOX® USER MANUAL
Spin X, Y, Z
The Spin X, Y, and Z parameters allow the size of content on a layer to be adjusted on a per-axis basis. While the Spin Z
parameter can affect both textures and objects, the Spin X and Y parameters can only affect objects.
Mix Select and Mode
The Mix Select and Mix Mode parameters are used to assign the layer’s rendering to a mix and to select which of the mix
properties is assigned (centering, cropping, scaling, etc.)
Blend Mode
The Blend Mode parameter is used to select which blending mode (source over, additive, subtractive, etc.) is used when
compositing the layer on top of lower numbered layers.
Draw Mode
The Draw Mode parameter is used to select the draw mode (stenciling) for the layer.
Image Remapping Conguration
The Image Remapping Conguration parameter is used to select from the available congurations for image remapping
on the layer. Image remapping congurations are created on the Image Remap tab of Mbox or Mbox Remote.
Layer Effects
The Layer Effects are pulled from both the shader-based texture effects and the object effects. The effect will be applied
only across the imagery in the layer, not affecting imagery on other layers. Each layer effect has ve modiers.
Layer Volume
The Layer Volume parameter affects the output volume of audio content on the layer, not affecting audio volume on other
layers.
Layer DMX Timecode
The Layer DMX Timecode parameters may be used to apply a live timecode sync value to movie content on the layer
when a timecode sync play mode is used. With all four parameters set to their default value of 0, the layer will use an
alternate method for linking the le to timecode - e.g. the MediaInfo.plist le. Each parameter has a different allowable
range: Hours = 23, Minutes = 59, Seconds = 59, Frames = 29.