Table of contents
1 Introduction........................................................................... 5
2 Safety and responsibility....................................................... 6
2.1 Labelling of Warning Information.................................. 6
2.2 General safety information............................................ 7
2.3 Intended use................................................................. 8
2.4 User qualification.......................................................... 9
2.5 Network security......................................................... 10
3 Storage and Transport........................................................ 11
4 Assembly and Installation................................................... 12
4.1 Wall mounting............................................................. 12
4.2 Control panel mounting............................................... 14
4.3 Electrical installation................................................... 15
4.3.1 Cable Cross-Sections and Cable End Sleeves....... 15
4.3.2 Preparation.............................................................. 16
4.3.3 Connecting the terminals......................................... 18
4.4 Primary Power Connection......................................... 18
4.5 Connection of measuring inputs................................. 18
4.5.1 PT100 / Pt1000 input RI1........................................ 19
4.5.2 Conductivity input RI2.............................................. 19
4.5.3 Isolated analog inputs 4…20mA AI1 & AI2.............. 20
4.5.4 Digital inputs DI1 to DI5........................................... 21
4.5.5 Serial input SI1........................................................ 22
4.6 Self-powered relay PO1.............................................. 22
4.7 Potential-free relays (FO1 to FO4)............................. 22
4.8 Electronic relay outputs connections RO1.................. 24
4.9 4…20 mA outputs (AO1 to AO2)................................ 25
4.10 Power supply output (PWR)..................................... 25
4.11 RS485 communication bus connections................... 26
4.11.1 Connection to a USB port of a computer............... 26
4.11.2 Polarization and termination of the RS485 bus..... 27
5 Commissioning................................................................... 28
5.1 Connection to Modem................................................. 28
6 Display Mode and Type...................................................... 30
6.1 Main Screen................................................................ 30
6.2 Operating Graph......................................................... 33
7 General Menu..................................................................... 34
7.1 SETUP MENU............................................................ 34
7.1.1 OPTIONS................................................................. 34
7.1.2 ANALOG INPUT SETTINGS................................... 37
7.1.3 DIGITAL INPUT SETTINGS.................................... 40
7.1.4 MEASUREMENT SETTINGS.................................. 41
7.1.5 OUTPUT SETTINGS............................................... 44
7.1.6 CONDITIONS & FUNCIONS................................... 48
7.1.7 COMMUNICATION.................................................. 49
7.1.8 FACTORY RESET................................................... 56
7.2 SETTINGS.................................................................. 57
7.2.1 TOWER MANAGEMENT......................................... 58
7.2.2 BIOCIDE A TIMERS................................................ 59
7.2.3 BIOCIDE B TIMERS................................................ 60
Table of contents
3
To Next Page
Loading...
Need help?
General
