ProMinent DULCOMETER - Settings

Factory
default set‐
tings
Click on it to select the desired default setting:
n Custom (select sensors and outputs)
n Configuration 1 : CTFS conductivity Volume –
Bio A - Inhibitor
n Configuration 2 : CTFS conductivity Volume –
Bio A – Inhibitor - ORP
n Configuration 3 : CTFS conductivity Volume –
Bio A – Inhibitor - Chlorine
n Configuration 4 : Volumetric mode Volume – Bio
A – Inhibitor
n Configuration 5 : Resistive conductivity Volume
– Bio A – Inhibitor
Sensor list Select desired sensor configuration from predefined
configuration:
n CTFS Sensor (SI1)
n Temperature Sensor (RI1)
n Conductivity Sensor (RI2)
n Volume counter (DI1)
n Flow-switch contact (DI2)
Output list Select desired output configuration from predefined
configuration:
n Bleed valve (PO1) - is always selected.
n Biocide A (FO1)
n Biocide B (FO2)
n Inhibitor (FO3)
n Dispersant (FO4)
Fig. 63: Upload configurations
7.2 SETTINGS
After the configuration of inputs and outputs in the setup menu,
detailed configurations like timers, setpoint and alarms can be
done in this menu.
General Menu
57